1. This is an optional step. It's important to have one made of lightweight fibers or a slightly loose weave so you can actually do the hand sewn step.
However, I could not find a basket I like so I opted for a plastic woven place mat. You can skip steps 1 to 4 if you find a basket to use
2. Fold your place mat at an angle so 2 adjacent edges meet. Measure a specific distance from the point to determine your seam line. Stitch down that line similar to the "line" in the photo.(I measured in 3 inches.)Complete on all 4 corners.
3. This is what your "basket" will look like.
4.Turn your "basket right side out so that the flaps are on the inside. Later you can tack them down.
5. OKAY EVERYBODY: Measure the circumference of your basket. That is the outer edge that will be sewn to your fabric.
Add 1 - 1 1/4 inches to that measurement. This is how wide your fabric and liner will need to be. How deep you want your bag is up to you. I believe mine was 9 inches.
But I wanted some pockets in my bag. The easy way to do this is add some to your liner depth. In my case I added 8 inches to make 4 inch deep pockets. It's kind of a tricky step because you want to make sure you have enough fabric to be able to sew your pockets to. Look at the next instructions if you're not sure.
If you want to make pockets, the next 2 steps are for you.
6.Fold the liner lengthwise about half way down. For your own sanity mark with your finger where your pocket bottom will be, fold it over and determine if your pocket is in the right place...you do not want a pocket top that lays above the edge of your liner. In fact you will want it to be atleast an inch below the top raw edge.
Once you are sure of this, press your fold with an iron!
Lets say your pocket is going to be 4 inches deep, sew lengthwise down your liner 4 inches from the folded edge. Then sew about 1/4 of an inch from the folded edge to keep your pocket nice.
7. Next open up you liner lengthwise so that there is a raw edge on top and on bottom. Fold over your pocket, press with an iron, and sew similar to the lines in the photo top make you pockets.
8.Determine where your straps need to be on your outer fabric. You can fold it in half width wise to determine if the match up and are centered. Pin the straps in place
I used that pre-made strap stuff you buy ay the store (what is it called?) You can make your own straps if you want to.
Place your liner over this with right sides together. Pin and sew about 5/8 from the edge.
Then fold the joined pieces width wise and sew 5/8 from the edge to create the side seam. Your fabric will resemble a tube.
9.Turn and press. Sew about 1/4 inch from the folded edge.
10. Pin, clamp or hold your outer fabric to your basket. It must be right facing the basket, raw edge up and aligned with the top of the basket.
Using button/carpet thread and a needle, hand stitch a straight line in and out of the fabric and basket. To see better details Click here
11.If you made your own "basket" You can turn it wrong side out again to make this step easier. So those of you that are using a real basket be aware that this picture wont match what you are doing but the instructions are the same.
You are basically hemming or tacking down the liner's raw edge. Turn the raw edge under and with the same kind of thread and needle, "catch" the fabric and part of the basket.
12. If your bag is wrong side out, turn it right side. There you have your own basket bag! Remember to email me with questions and let me know if you make a bag.